Getting it up Down Under
Sign Up!
Welcome to
Tuesday, September 26 2017 @ 01:05 AM AEST

Delay adjusting tool (ProDAT) Recall Alert

Loki Research's Jeff Taylor has issued the following notice:-

It has come to my attention that some ProDAT delay adjusting tools sold in 2007 and 2008 are defective.

The problem is that the drill bit is set into the handle at the wrong height (too high). The result is that the delays are drilled deeper than expected and the delay times are too short by as much as five seconds. This can be catastrophic! Please check any ProDATs that you have and contact me if you find bad ones. The correct overall length to the tip of the drill bit is 1.675", the bad ones that I have seen are in the 1.8" to 1.82" range.
See for a drawing.

I will replace any bad tools, regardless of where you bought them.


Story Options



My Account

Sign up as a New User
Lost your password?


There are no upcoming events

Older Stories

Thursday 13-Nov

Friday 29-Aug

Monday 05-May

Wednesday 05-Mar

Tuesday 04-Mar

Saturday 22-Dec

Friday 07-Dec

Thursday 29-Nov

Tuesday 02-Oct

Monday 01-Oct